21
6.
Press
to select the desired time.
The time can be set between 0:00 and 23:50 in 10 minute intervals.
•
To return to the mode setting, press
•
.
Go to STEP
•
9
when setting the OFF TIMER.
Press
7.
.
The time will be set.
•
“
•
” and the temperature blink.
Press
8.
to select the desired temperature.
The temperature can be set between 10°C and 32°C.
•
Cooling: The unit operates at 18°C even if it is set at 10 to 17°C.
Heating: The unit operates at 30°C even if it is set at 31 to 32°C.
To return to the time setting, press
•
.
The set temperature is only displayed when the mode setting is on.
•
Press
9.
.
Be sure to direct the remote controller toward the indoor unit and check for a receiving tone
•
and
fl
ashing the OPERATION lamp.
The temperature will be set and go to the next reservation setting.
•
To continue further settings, repeat the procedure from STEP
•
4
.
The TIMER lamp lights yellow.
•
Press
10.
to complete the setting.
“
•
” is displayed on the LCD and WEEKLY TIMER operation is activated.
Control panel
A reservation made once can be easily copied and the same settings used for another day of the week.
•
Refer to
Copy mode
.
Page 22
NOTE
Notes on WEEKLY TIMER operation
Do not forget to set the clock on the remote controller
fi
rst.
•
Page 9
The day of the week, ON/OFF TIMER operation, time and set temperature (only for ON TIMER operation) can be set with WEEKLY TIMER.
•
Other settings for ON TIMER are based on the settings just before the operation.
Both WEEKLY TIMER and ON/OFF TIMER operation cannot be used at the same time. The ON/OFF TIMER operation has priority if it is set
•
while WEEKLY TIMER is still active. The WEEKLY TIMER will go into standby state, and “
” will disappear from the LCD. When
ON/OFF TIMER is up, the WEEKLY TIMER will automatically become active.
Only the time and set temperature set with the weekly timer are sent with the
•
.
Set the weekly timer only after setting the operation mode, the fan strength, and the fan direction ahead of time.
Shutting the breaker off, power failure, and other similar events will render operation of the indoor unit’s internal clock inaccurate. Reset the
•
clock.
Page 9
The
•
can be used only for the mode, time and temperature settings.
It cannot be used to go back to the reservation number.
01_EN_3P278434-5C.indd 21
01_EN_3P278434-5C.indd 21
8/18/2016 1:21:21 PM
8/18/2016 1:21:21 PM
