27
4.3 Functional description
You can set the various functions by pressing the keys (see
the keys function chapter).
The remote control supplied with the device is designed
to provide maximum sturdiness and exceptional
functionality, but should nonetheless be handled with
caution.
Avoid:
- leaving it exposed to rain, spilling liquid on the keyboard
or dropping it in water
-
bumping it forcefully or letting it fall on hard surfaces
-
leaving it exposed to direct sunlight
-
placing obstacles between the remote control and the
device while you are using the remote.
Moreover:
-
if other devices are being used within the premises that
are operated by remote control (TVs, radios, stereos,
etc.), you might experience some interference
- electronic and fluorescent lamps can interfere with
communications between the remote control and the
device.
-
remove the battery in case of prolonged inactivity of the
remote control.
Use only a dry 3V lithium battery CR2025 (included) with
the remote control. Used batteries must be disposed of
appropriately (WEEE) through special waste collection
centres provided by the local authorities.
To insert the battery, open the slot on the bottom of the
remote control. Make sure to insert the battery according
to the +/- polarity. Close the cover after inserting the
battery.
To control the device with the remote control or touch-screen
display, make sure you have enabled the main switch on the
power line (the technician who installed the device can help
you locate the switch), or introduce a power plug on the
device, plugging it into the system’s socket.
After you perform these steps, you can operate the system
either by pressing the symbols on the touch-screen display
or using the remote control. To send commands to the indoor
unit, point the front of the remote towards the unit’s display.
The buzzer will emit a beep and a message will appear on
the display to confirm that the command has been enabled.
The maximum range to send commands is about 8 metres.
Main switch-on and operation
Inserting the battery
Key/Display
Operation
The keys of the remote control and touch-screen display perform the same function.
When the unit is switched on, the preset set-point appears on the 3 digits of the display.
•
The room temperature set-point can range between 16 and 31 °C.
Do not set a temperature that is too low or too high is harmful to health and is an unnecessary
waste of energy.
