12
2.5
A
B
D
C
Wall installation
•
For smooth installation, especially if you want to
set-up the system before you install the device, we
recommend installing a wall recess, as shown in the
figure;
•
If you do not complete installation of the device
when installing the wall recess, leave the water and
condensate drain pipes hanging loose, so that you
can later make the connections without joints;
•
When you finally install the device, it will be possible
to connect the convector with a 90° fitting and socket
with eurokonus connection;
•
another option if you can comfortably bend the
pipeline (which will depend on the depth of the
installed recess) is to install the eurokonus connection
inside the pipeline;
•
pay attention to the tilt angle of the condensate drain
pipe, which must rest be laid on the lowermost part
of the recess so that the pipe’s height never exceeds
the height of the cooler-radiator drain connection;
•
for the installation heights, refer to the installation
template supplied with the device and which is shown
in the following pages.
A
wall recess
B
connecting water pipelines
C
condensation drainage pipe
D
heat pump convector
