31
5.3
5.4
5.5
5.6
Keys function
You can set the various functions through the 8 backlit
keys:
Temp + allows increasing the
set temperature
Temp - allows decreasing the
set temperature
Heating/Cooling: allows
switching between heating and
cooling
The ventilation speed will be
adjusted automatically between
a minimum and a maximum
value.
Night function: the ventilation
speed is significantly reduced
and the set temperature is
changed automatically
Operation at maximum speed:
allows setting he maximum
ventilation speed
ON/Stand-By: allows activating
or putting the device in stand-
by mode.
Silent operation: allows limiting
the ventilation speed by
reducing its maximum value.
General start-up
Activation
Heating / cooling operating mode set-up
In order to control the device from the control panel, it first
has to be connected to mains.
If a main power switch has been installed on the power
line, it must be activated.
- Start the system by toggling the main switch
To activate the device
Key
Operation
Display
Press ON-Standby key
From off to on state
Pressing function key select one of four possible function modes.
Key
Operation
Display
Press the Heating / Cooling key for about 2 seconds to switch between heating and
cooling operating modes; the selection is shown by the heating or cooling symbols
that will light up.
In heating, the symbol is alight when the setpoint is higher than the room temperature,
and switched off when the setpoint is lower.
In cooling, the symbol is alight when the setpoint is lower than the room temperature,
and switched off when the setpoint is higher.
