9
2.1
2.2
20
20
120
2.3
INSTALLATION
Unit placement
Installation procedure
Daikin
FWXT convectors have to be installed only in high
wall position, above 2 meters.
Avoid installing the unit near:
-
areas exposed to direct sunlight;
- heat sources;
- in damp areas and areas in which the unit can come into
contact with water;
- in environments with oil mists;
- in environments subject to high frequencies.
Make sure that:
-
the wall on which you intend to install the unit is strong
enough to support the weight;
- the wall surface is not crossed by pipelines or power lines;
- the wall is perfectly flat;
- there are no obstructions nearby that could compromise
the inlet and outlet airflow;
- the wall on which you are installing the unit is (if possible)
an external perimeter wall, in order to allow condensate
drain outside the premises;
- air flow is not directed towards by-standers.
The assembly steps described below and their drawings
refer to a version of the machine with connections on the
right side.
For ideal installation and performance levels, carefully
follow the instructions in the manual.
Failure to do so may cause system malfunctions and
automatically voids the warranty, and relieves the
manufacturer of any harm caused to persons, animals
or property.
Installation space
The figure shows the minimum distances required for the
convector from the walls and furniture on site.
