Daikin homecontrols EKRSENDI1BA, Installer And User Manual

12

Start-up

Start-up

5 

Start-up

5.1 

Connecting to the DHC Access Point

Read this entire section before starting to 

connect other accessories.

First set up your DHC Access Point via the 

ONECTA app to enable operation of other DHC ac-

cessories within your ecosystem. For further infor-

mation, see the manual of the DHC Access Point.

To integrate the DHC Room Sensor into your ecosystem 

and enable it to communicate with other DHC accessories, 

you must connect it to your DHC Access Point first. To do 

so, proceed as follows:

1.  Open the ONECTA app.

2.  Click on the plus symbol (+).

3.  Select the menu item 

Add Daikin Home Controls

.

4.  Select 

Add DHC Accessory

. 

5.  Remove the sensor 

(B)

 from the frame by grab-

bing the sides of the sensor and pulling it out (

see 

figure 2

).

6.  Turn over the sensor.

7.  Remove the insulation strip from the battery com-

partment. 

» Connection mode remains activated for 3 minutes.

You can manually start the connection mode for 

another 3 minutes by pressing the system button  

(C)

 shortly (

see figure 3

).

8.  Follow the instructions in the app.

5.2 

Mounting

Read this entire section before starting to mount 

the accessory.

You can use the supplied clip-on frame 

(A)

 to mount the 

DHC Room Sensor or easily integrate it into an existing 

switch (see „5.2.2 Screw mounting“ on page 14).

You can fix the DHC Room Sensor to a wall with:

•  the supplied double-sided adhesive strips, or

•  the supplied screws.

You can also mount the DHC Room Sensor on a 

flush-mounted box.

5.2.1  Adhesive strip mounting

To mount the DHC Room Sensor using the adhesive strips, 

proceed as follows:

1.  Choose a site for installation.