SiBE041025
Operation Manual
Operation Manual
45
2.8
ON TIMER Operation
17
ON TIMER Operation
To use ON TIMER operation
1. Press .
• “ ” disappears from the LCD.
3. Press again.
• “ ” and setting time are displayed on the LCD.
• The TIMER lamp lights up.
To cancel ON TIMER operation
4. Press .
• “ ” disappears from the LCD.
• “ ” is displayed on the LCD.
• The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
NOTE
“ ” is displayed on the LCD.
“ ” blinks.
In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
(Example)
Present time: 23:00
(The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
Display
• Check that the clock is correct. If not, set the clock to the
present time.
2. Press until the time setting reaches the
point you like.
• Each pressing of either button increases or decreases the
time setting by 10 minutes. Holding down either button
changes the setting rapidly.
3P253185-6
