SiBE061121
Operation Manual
Operation Manual
61
2.11 ON TIMER Operation
20
ON TIMER Operation
To use ON TIMER operation
Check that the clock is correct.
•
If not, set the clock to the present time.
Page 10
Press
1.
.
“
•
” is displayed on the LCD.
“
•
” blinks.
“
•
” and day of the week disappear from the LCD.
Press
2.
until the time setting reaches the
point you like.
Each pressing of either button increases or decreases the time setting by 10 minutes.
•
Holding down either button changes the time setting rapidly.
Press
3.
again.
“
•
” and setting time are displayed on the LCD.
The OPERATION lamp blinks and the TIMER lamp lights yellow.
•
Page 5
Display
To cancel ON TIMER operation
Press
.
“
•
” and setting time disappear from the LCD.
“
•
” and day of the week are displayed on the LCD.
To combine ON TIMER and OFF TIMER
A sample setting for combining the 2 timers is shown below.
•
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
Combined
ON TIMER at 14:00
(Example)
NOTE
In the following cases, set the timer again.
After a breaker has turned off.
•
After a power failure.
•
After replacing batteries in the remote controller.
•
SiBE061121.book Page 61 Friday, April 22, 2011 4:12 PM
