25
Advanced Settings
Advanced Settings
HUM lamp (Low)
MODE ECONO lamp
Note
Settings are remembered even if the unit is unplugged.
Settings of Modes within ECONO MODE
If you wish to set ECONO MODE and AUTO operation monitoring mode to “OFF”
You can set ECONO MODE and AUTO operation monitoring mode to “OFF”. (Setting at time of purchase: ON)
If you are concerned about the sensitivity of the dust/PM2.5 sensor, odour sensor, or humidity sensor, set to “OFF”.
1.
Hold down
for about 5 seconds and when a short beep sounds, press
while pressing
.
(Setting can be performed either during operation or while operation is stopped.)
2.
When a short beep sounds, release
and
.
• The HUM lamp “ (Low)” and ECONO MODE lamp blinks for about 5 seconds and then lights up.
The ECONO MODE lamp will light up or blink depending on the setting status.
3.
Press
to change the setting.
• Each press turns the ECONO MODE lamp ON or OFF.
(The HUM lamp “ (Low)” will remain lit up.)
To turn Monitoring mode
ON
Turn on the ECONO MODE lamp.
Setting at time of
purchase
ON
OFF
To turn Monitoring mode
OFF
Turn off the ECONO MODE lamp.
• Setting is indicated using the ECONO MODE lamp. If the ECONO MODE lamp does not change, unplug the unit, wait at
least 5 seconds, then re-insert the power supply plug and repeat the above procedure from the beginning.
4.
Press
after selecting the new setting.
• A short beep sounds and the HUM lamp “ (Low)” will blink. When monitoring mode is turned ON, the ECONO MODE
lamp also blinks.
5.
While the lamp is blinking, unplug the power supply plug, wait at least 5 seconds, and then insert the
power supply plug again. Setting is now complete.
• If this procedure is not performed, the unit will not return to regular operation mode.
Operating panel
