17
Preparation Before Operation
Read First
WARNING
Be sure to stop the operation and remove the power supply
plug before installation. (Electric shock or injury may result)
When supplying water in the water tank
1.
Take out the water tank.
1 Securely hold the grip on the water tank and slowly
pull the tank toward you while pressing the lever.
Lever
Grip
2 Take out the water tank
by holding down the side
lock part on the water
tank with a finger to
unlock.
Side lock part
•
When releasing the side lock part, be sure to
support the water tank with your hand.
2.
Fill the water tank with tap water.
• Perform in a place where
spilling water will not cause
a problem.
• Clean the water tank by
shaking a small amount of
water inside before filling up
the water tank with water.
For maintenance
procedures refer to
►
Page 37, 38
[Viewed from below]
Avoid touching the
valve in the centre.
(Water in the water
tank may leak)
•
Do not remove the lid of the water tank when
filling with water.
(Water leakage may result from foreign matter
entering the tank)
The metal filter at the spout prevents foreign matter
from entering.
•
The water tank will weigh about 3.3kg when filled
up to the full line.
Hold the water tank firmly with both hands when
carrying.
When carrying, fill to here
Full line
• Do not supply water beyond the full line of the water
tank.
(Water may spill when carrying the water tank or
installing it into the unit)
• Since the top surface is not sealed, water will spill if
the tank is tilted too much.
• If the water tank contains water, do not place it on
the floor or carpet. (The valve in the centre may be
pushed and water may spill)
3.
Install the water tank.
• Hold the grip and install
the water tank in the
unit by fitting it into the
humidifying tray.
•
Do not touch the side lock
part when installing.
(Fingers may get caught)
Water tank
1 Insert to match
this part
Humidifying tray
2 Press until a catching
sound is heard
6
Insert the power supply plug into the
power socket
• The basic sensitivity of the odour sensor will be determined
by odour levels in the first minute (approx.) after the power
supply plug is inserted.
Insert the power supply plug when the air is clean
(odour-free).
Power supply plug
Power socket
01_EN_3P693798-1B.indd 17
2023/06/26 13:34:00
