SiBE81-909
Operation Manual
Humidifying Air Purifier
45
36
6
Restore the humidifying tray.
• Reattach the humidifying filter and waterwheel to
the humidifying tray, and push the humidifying tray
back into the unit until hearing clicking sound.
Humidification cannot be run unless the humidifying
filter is properly installed.
7
Restore the water tank and front panel.
(About once every 3 days)
1
Remove the front panel and water tank.
2
Pull out the humidifying tray and remove the waterwheel and humidifying filter.
3
Rinse the humidifying tray in water.
4
Restore the humidifying tray.
5
Restore the water tank and front panel.
• Do not remove the float or silver ion cartridge.
• Without the float, humidifying operation cannot be run. Without
the silver ion cartridge, the antibacterial, anti-mildew and slime
prevention effects are disabled.
• Depending on the water quality and environment of usage, the
accumulated water in the humidifying tray may be discolored by
scale etc.
If that occurs, follow the instructions above and clean the tray.
Waterwheel
Humidifying
filter
Attach the humidifying
filter and waterwheel.
Press inward until
hearing clicking
sound.
Install the humidifying filter and waterwheel in the direction shown in the figure.
X
Page 29.
X
Page 29.
X
Page 35.
For stubborn scale
• Dissolve citric acid in lukewarm or plain water
and moisten a soft cloth or soft bristle brush
with the water.
Remove scale with the soft cloth or the soft
bristle brush.
Rinse off thoroughly with clean water.
* About the quantity of citric acid, refer to “For
stubborn scale (white or brown)”.
X
Page 35.
X
See above.
X
Page 29.
ATTENTION
Float
Silver ion cartridge
Effective against bacteria,
mildew and slime.
Rinse with water
Humidifying tray cleaning
