9
Residual risks
Despite having implemented and adopted all the safety measures indicated by applicable regulations,
some residual risks remain. In particular, in some operations of replacement, adjustment and tooling
maximum attention is always required in order to work in the best possible conditions.
List of operations with residual risks
Risks for qualified personnel (electrician and mechanic)
-
Handling - during unloading and handling it is necessary to pay attention to all the steps listed in this manual regarding the points
of reference
-
Installation - during installation it is necessary to pay attention to all the steps listed in this manual regarding the points of reference
The installer must ensure the static and dynamic stability of the machine's site of installation.
-
Maintenance - during maintenance it is necessary to pay attention to all the steps listed in this manual, and in particular to high
temperatures that may be present in the heat transfer fluid lines to/from the unit.
-
Cleaning - the machine must be cleaned only when it is switched off, by turning off the switch installed by the electrician and
the switch located on the unit itself. The key for interrupting the power supply must be kept by the operator until the end of the
cleaning operations. Internal cleaning of the machine must be carried out using the protections required by current regulations.
While the inside of the machine does not contain particular hazards, it is necessary to pay the utmost attention so that accidents
do not occur during cleaning. The heat exchange coils that have a potentially sharp finned pack must be cleaned using protective
glasses and gloves suitable for handling metals.
During adjustment, maintenance and cleaning there are residual risks of variable entity. Being operations
that must be performed with guards disabled, it is necessary to pay particular attention in order to avoid
damage to persons and things.
Always pay close attention when performing the operations specified above.
Remember that these operations must always be performed by authorised personnel.
All work must be completed in accordance with the legal provisions relating to work safety.
Remember that the unit in question is an integral part of a larger system that includes other components,
depending on the final characteristics of realisation and the mode of use. Therefore in the end it is
the responsibility of the user and assembler to assess the residual risks and their respective preventive
measures.
Safety devices
The machine is equipped with safety devices to prevent risks of damage to persons and for
proper operation. Always pay attention to the symbols and safety devices on the machine. It
should
only
operate with the safety devices engaged and with fixed or movable guards
installed correctly and in the proper position.
If during installation, use or maintenance the safety devices have been temporarily removed
or disabled, the machine can be operated
exclusively
by the qualified technician who made
this change. It is
mandatory
to prevent other people's access to the machine. When finished,
restore the devices to their proper status as soon as possible.
This publication is drawn up only as technical support and does not constitute a binding commitment for Daikin Applied Europe S.p.A. Daikin Applied Europe S.p.A. has drawn up the content
to the best of its ability. No explicit or implicit guarantee is given as to the completeness, precision or reliability of its content. All the data and specifications contained herein are subject to
change without notice. The data stated at the time of the order prevail. Daikin Applied Europe S.p.A. accepts no liability whatsoever for any direct or indirect damage, in the broadest sense of
the word, deriving from or associated with the use and/or interpretation of this publication.
All content is protected by the copyright of Daikin Applied Europe S.p.A.
