3
English
Never touch the internal parts of the remote controller.
Touching certain internal parts will cause electric shocks
and damage to the remote controller. Consult your local
dealer about checking and adjustment of internal parts.
To avoid oxygen deficiency, ensure that the room is
adequately ventilated if equipment such as a burner is
used together with the air conditioner.
Do not leave the remote controller wherever there is a
risk of wetting.
If water gets into the remote controller there is a risk of
electrical leakage and damage to electronic components.
Watch your steps at the time of air filter cleaning or
inspection.
High-place work is required, to which utmost attention must
be paid.
If the scaffold is unstable, you may fall or topple down, thus
causing injury.
Do not remove the outdoor unit’s outlet side grille.
The grille protects against the unit’s high speed fan, which
may cause injury.
To avoid injury, do not touch the air inlet or aluminum
fins of the air conditioner.
Do not place objects that are susceptible to moisture
directly beneath the indoor or outdoor units.
Under certain conditions, condensation on the unit or
refrigerant piping, air filter dirt or drain blockage may cause
dripping, resulting in fouling or failure of the object
concerned.
Do not place heaters directly below the indoor unit, as
resulting heat can cause deformation.
Do not place appliances that produce naked flames in
places exposed to the airflow from the air conditioner
as this may impair combustion of the burner.
Do not block air inlets nor outlets.
Impaired airflow may result in insufficient performance or
trouble.
Do not use the air conditioner for purposes other than
those for which it is intended.
Do not use the air conditioner for cooling precision
instruments, food, plants, animals or works of art as this
may adversely affect the performance, quality and/or
longevity of the object concerned.
Do not install the air conditioner at any place where
there is a danger of flammable gas leakage.
In the event of a gas leakage, build-up of gas near the air
conditioner may result in a fire.
Carry out drain piping properly to ensure complete
drainage.
If drain piping is not carried out properly, drain will not flow
out. Then, dirt and debris may be accumulated in the drain
piping and may cause water leakage. If it occurs, stop the
air conditioner and call your local dealer for assistance.
• NOTE TO SERVICE PERSONNEL
WARNING
RISK OF ELECTRIC SHOCKS OR A FIRE
•
When checking the electric components (such
as the inside of the control box, fan motor, drain
pump, etc.), make sure to shut off all power
supply for the air conditioner (including both
indoor and outdoor units).
•
When cleaning the heat exchanger, make sure
to remove the electronic components above (If
they get cleaning agent, there is a risk that the
components will burn out because of insulation
degradation).
CAUTION! DANGER OF ELECTRIC
•
Shut off power supply before work.
•
Never open the control box lid for 10 minutes
after shutting off the power supply because
there is residual voltage.
•
After opening the control box lid, measure
residual voltage between the points shown in
Fig. 1
on the printed circuit board by the tester
without touching the live part and confirm that
the residual voltage is DC50V or below.
•
After power failure, operation will restart
automatically.
2. WHAT TO DO BEFORE
OPERATION
This operation manual is for the following systems
with standard control.
Before initiating operation, contact your local dealer
for the operation that corresponds to your system.
Figure 1
1
Control box
2
Printed circuit board
3
Measuring points for residual voltage
A
Pair system or simultaneous operation system
- +
0
A1P
X1M
C -
C +
X27A
C-
C+
1
2
3
A
1
2
OUTDOOR
INDOOR
4PEN465543-1D.book Page 3 Monday, February 25, 2019 9:26 AM