16 Operation
Installer and user reference guide
63
SERHQ020~0 SEHVX20~64BAW
Split packaged air-cooled water chiller
4P508020-1B – 2018.04
INFORMATION
Press
to return to previous steps in the programming
procedure without saving modified settings.
1
Press to enter the programming/consulting mode.
2
Select the operation mode you would like to program using
and
.
Result:
The actual mode is blinking.
3
Press to confirm the selected mode.
Result:
The actual day is blinking.
4
Select the day you would like to consult or to program using
and
.
Result:
The selected day is blinking.
5
Press to confirm the selected day.
6
Hold down for 5 seconds to program the detailed actions.
Result:
The first programmed action of the selected day
appears.
7
Select the action number you would like to program or to modify
using .
8
Set the correct action time using
and
.
9
Set the leaving water temperature using
and
.
10
Set the room temperature using
and
.
11
Press
to select:
▪
: to switch heating and the remote controller off.
▪
: to select automatic temperature calculation for leaving
water temperature
12
Set the appropriate shift value using
and
. For
more information about weather dependent setpoint, see
"16.3.6 Schedule timer" on page 60
.
13
Repeat this procedure to program the other actions of the
selected day.
Result:
When all actions have been programmed, make sure
that the display shows the highest action number you would like
to save.
14
Press for 5 seconds to store the programmed actions.
Result:
If
is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored, but action 4 is deleted. You
automatically return to step 6. Press
several times to return
to previous steps in this procedure and finally return to normal
operation.
15
You automatically return to step 6; start again to program the
following day.
To program quiet mode
INFORMATION
Press
to return to previous steps in the programming
procedure without saving modified settings.
1
Press to enter the programming/consulting mode.
2
Select the operation mode you would like to program using
and
.
Result:
The actual mode is blinking.
3
Press to confirm the selected mode.
4
Consult the action(s) using
and
.
5
Hold down for 5 seconds to program the detailed actions.
Result:
The first programmed action appears.
6
Select the action number you would like to program or to modify
using .
7
Set the correct action time using
and
.
8
Select or deselect
as an action using
.
9
Repeat this procedure to program the other actions of the
selected mode.
Result:
When all actions have been programmed, make sure
that the display shows the highest action number you would like
to save.
10
Press for 5 seconds to store the programmed actions.
Result:
If
is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored, but action 4 is deleted. You
automatically return to step 6. Press
several times to return
to previous steps in this procedure and finally return to normal
operation.
11
You automatically return to step 6; start again to program the
following day.
To consult programmed actions
INFORMATION
Press
to return to previous steps in the consulting
procedure.
1
Press to enter the programming/consulting mode.
