SiENBE07-618_C
Operation Manual
System Configuration
53
ATTENTION
To use ON TIMER operation
•
Check that the clock is correct. If not, set the
clock to the present time.
1. Press “ON TIMER button”.
•
6:00
is displayed.
•
“
”blinks.
2. Press “TIMER Setting button” until the
time setting reaches the point you like.
•
Every pressing of either button increases
or decreases the time setting by 10
minutes. Holding down either button
changes the setting rapidly.
3. Press “ON TIMER button” again.
•
The TIMER lamp lights up..
To cancel the ON TIMER operation
4. Press “CANCEL button”.
•
The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
•
A sample setting for combining the two timers
is shown below
In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote control.
2
1, 3
4
Display
(Example)
Combined
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
SIENBE07-618_C_FRONT.pdf 65
9/02/2011 9:25:06
