SiBE121021_C
RA Indoor Unit
Operation Manual
197
To start 3-D Airflow
To cancel 3-D Airflow
2. 4. Press either the “SWING button ” or the “SWING button ”.
Notes on flaps and louvers angles
5˚
80˚
5˚
15˚
50˚
80˚
30˚
70˚
Upper limit
COMFORT AIRFLOW
COMFORT AIRFLOW
Lower limit
Stop operation
Upper limit
Lower limit
Upper limit
Lower limit
In HEAT mode
In FAN mode
Stop operation
Stop operation
1. 3. Press the “SWING button ” and the “SWING button ”:
the “ ” and “ ”display will light up and the flap and louvers will
move in turn.
In DRY mode or
COOL mode
• When “
SWING button
” is selected, the flaps
swinging range depends on the operation mode.
(See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates
cold air, which tends to collected at the
bottom of the room, and hot air, which tends
to collect near the ceiling, throughout the
room, preventing areas of cold and hot
developing.
ATTENTION
• Always use a remote controller to adjust the
angles of the flaps and louvers. If you
attempt to move it forcibly with hand when it
is swinging, the mechanism may be broken.
• Always use a remote controller to adjust the
louvers angles. In side the air outlet, a fan is
rotating at a high speed.
