5
■
Outdoor Unit
■
Indoor Unit
1. Air filter
2. Titanium Apatite Photocatalytic
Air-Purifying Filter:
• These filters are attached to the inside of
the air filters.
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the
unit.
7. INTELLIGENT EYE sensor:
(page 14.)
8. Display
9. Air outlet
10. Horizontal blades (flaps):
(page 12.)
11. Vertical blades (louvers):
• The louvers are inside of the air outlet.
(page 12.)
12. Indoor Unit ON/OFF switch:
(page 10.)
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
• This switch is useful when the remote
controller is missing.
13. Operation lamp (green)
14. TIMER lamp (yellow):
(page 20.)
15. INTELLIGENT EYE lamp (green):
(page 14.)
16. Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will
hear a short beep.
• Operation start ........ beep-beep
• Settings changed ..... beep
• Operation stop.......... beeeeep
■
Outdoor Unit
17. Air inlet:
(Back and side)
18. Refrigerant piping and inter-unit cable
19. Drain hose
20. Earth terminal:
• It is inside of this cover.
21. Air outlet
20/25/35/42 class
50 class
18
19
20
21
17
18
19
20
21
17
Model
Mode
Temperature
setting
Airflow
rate
COOLING
ONLY
COOL
22°C
AUTO
HEAT
PUMP
AUTO
25°C
AUTO
01_EN_3P207037-1B.fm Page 5 Friday, September 28, 2007 2:04 PM
