PIM-00004
△
1
[Operation Manual]
13/61
DAIKIN INDUSTRIES, LTD.
[8.
Precautions for Operation, Transportation and Installation]
In order to suppress vibration and noise, vibration suppressing rubber is attached to each mounting leg.
Before shipment, it is fastened with fastening wing bolts (M8 L30: at two places) in order to suppress
transport vibration.
Precautions for operation
Before operation, remove the fastening wing bolts (M8 L30: at two places). Operating the unit without
removing the wing bolts may increase vibration and noise.
Precautions for transportation
During transportation, be sure to mount the motor base to the base with the fastening wing bolts (M8 L30:
at two places) to fasten it securely in order to protect the vibration suppressing rubber. (See the figure
below)
DANGER
If the hydraulic unit is lifted by any parts (e.g. pump pipes) other than the hook slots, the unit may fall or
turn over.
Check the weight of the hydraulic unit, and make sure that it does not exceed the rated load capacity of
each lifting sling.
WARNING
During transportation, make sure that the unit can be evenly lifted by the hook slots at four places.
During transportation using lifting slings, never come close to the unit. If the unit falls or turns over, you
may suffer from injury.
CAUTION
Avoid transporting the hydraulic unit with hydraulic oil contained in the tank.
(This may cause oil leak, or malfunction due to air intrusion.)
During transportation, hold the hydraulic unit securely so that it will not be moved by vibration or
external force.
Hook slot
(at four places)
Transport nameplate
Bolt
nameplate
Fastening wing bolts
(at the back of the unit two places)