PIM-00004
△
1
[Operation Manual]
38/61
DAIKIN INDUSTRIES, LTD.
P39
Digital output selection
(See the next page.)
0
0: Completion output
1: Motor operation output
2: High-pressure pump
operation output
−
Specify the signal to be output from digital
output terminal 0.
P40
Pump operation
selection
0
0: Autonomous switching
operation
1: High-pressure,
small-capacity pump
operation
−
You can specify operation of the high-pressure,
small-capacity pump only.
・
Normally, the P05, P10 and P11 settings need not to be changed. However, if a special circuit condition
(large load volume, etc.) is expected, these settings must be changed.
・
This hydraulic unit allows 16 patterns from PQ selection numbers 0 to 15 to be set; when using a
single pattern only, however, select
“
PQ selection 0.
”
The pressure and flow rate can be set larger than the operating ranges specified in the above table. However,
the hydraulic unit must be operated at pressure and flow rate within the above pressure ranges.