11 |
P a g e
5
HANDLING
Transportation
Block equipment from sliding on lorries to prevent damage to the panels and base frame. Avoid
bumping, jolting and impacts during unloading and/or moving the machine. Do not push or pull
the equipment from any part other than the base frame. Failure to follow above-mentioned
instructions could cause serious damages for which the manufacturer will not be held liable.
Receiving the machine
The machine must be inspected for any possible damage immediately upon reaching its final place
of installation. All components described in the delivery note must be carefully inspected and
checked. Any damage must be reported to the carrier. Before connecting the machine to earth,
check that the model and power supply voltage shown on the nameplate are correct.
Responsibility for any damage after acceptance of the machine cannot be attributed to the
manufacturer.
To prevent the possibility of incomplete delivery (missing parts) or transport damage, please
perform the following checks upon receipt of the machine:
•
Before accepting the machine, please verify every single component in the consignment.
Check for any damage.
•
In the event of the machine has been damaged, do not remove the damaged material. A
set of photographs are helpful in ascertaining responsibility.
•
Immediately report the extent of the damage to the transportation company and request
that they inspect the machine.
•
Immediately report the extent of the damage to the retailer, so that arrangements can be
made for the required repairs. In no case must the damage be repaired before the
machine has been inspected by the representative of the transport company.
Lifting
Use proper lifting method:
•
Please use spreader bar and the lifting holes of the machine when lifting to avoid damage
to the equipment. The hoisting belt (such as tight wire, nylon) should be doubled and
not shorter than ten meters (or four not shorter than five meters), and both sides of pole
should be extended over 100mm out of unit in order to prevent the hoisting belt from
damaging unit.
•
The increase of length and weight of UAA245~450 units bring a lot of difficulties to
hoisting work. Use double lifting ropes and holes as that used for UAA105~220 units.
•
It is necessary that the unit maintains at level when being hoisted. Tilt angle should be
less than 15 degrees; otherwise the unit may be overturned.
Summary of Contents for UAA-ST3M
