Supplementary Explanation
Si-93
58
Supplementary Explanation
1.1.4
Field Setting
The following
shows the
procedure for field
setting using
remote controller of
new heat reclaim
ventilation unit.
List of field setting mode Nos.
(HL044)
Centralized control group No. setting
00
General setting
10-29
Centralized control group No. setting (group)
30
Error recode display
40
Sensor data
41
Forced fan ON
43
Individual setting
44
Unit No. reallocation
45
Step 1
To field setting mode
Press
for more than 4 sec.
Step 2
Mode No. selection 1
[Mode (00-30)]
→
[Mode (40-49)]
→
[Mode (50-59)]
(Press
for more than 4 sec.) (Press
for more than 4
sec. )
Step 3
Mode No. selection 2
Mode No.: UP
↔
Mode No.: DOWN
Step 4
Switch No. selection
(
) Switch No. selection
Step 5
Position selection
(
) Position selection
Step 6
Position enter
Enters currently selected position.
Step 7
To normal mode
Exits field setting mode and enters normal mode.
In group control, use
to select unit No.
Summary of Contents for VAM 1000EJ
