Si71-502
Safety Cautions
Operation Manual
69
• Young children should be supervised to ensure that they do not play with the appliance.
• Consult with installation contractor for cleaning the inside of the air conditioner.
Wrong cleaning may make the plastics parts broken or cause failure of water leakage or electric shock.
• Do not place objects in direct proximity of the outdoor unit and do not let leaves and other debris
accumulate around the unit.
Leaves are a hotbed for small animals which can enter the unit. Once in the unit, such animals can cause
malfunctions, smoke or fire when making contact with electrical parts.
Warning
(For Installation)
• Do not attempt to install the unit yourself.
Ask your dealer for installation of the unit.
Incomplete installation performed by yourself may result in a water leakage, electric shock, and fire.
• Installation should be done following the installation manual.
Incorrect installation may cause leaking, electric shock, or fire. Injuries may result if the unit falls.
• Do not allow exhaust air to enter the outside air intake vent.
This may cause the interior of the room to become contaminated and harming the health.
• Locate the outside air intake vent so that it does not take in exhaust air which contains
combustion air, etc.
Incorrect installation may cause a loss of oxygen in the room, leading to serious accidents.
• All wiring must be performed by an authorized electrician.
To do wiring, ask your dealer. Never do it yourself.
• Make sure that a separate power supply circuit is provided for this unit and that all electrical work
is carried out by qualified personnel according to local lows and regulations.
Insufficient power circuit capacity or incorrect work may cause electric shock or fires.
• Install the unit on a foundation strong enough to withstand the weight of the unit.
A foundation of in sufficient strongth may result in the unit falling and causing injuries.
• Connect the remote controller to the correct model.
This may cause electric shock or fire.
• Do not connect additional electric wirings.
This may cause fire.
• Do not install the HRV unit at any place where flammable gas may leak out.
If the gas leaks out and stays around the unit, a fire may break out.
• Be sure to establish an earth.
Do not earth the unit to a utility pipe, arrester, or telephone earth.
Incomplete earth may cause electrical shock, or fire.
A high surge current from lightning or other sources may cause damage to the air conditioner.
• Be sure to install an earth leakage breaker.
Failure to install an earth leakage breaker may result in electric shocks, or fire.
Caution
(For Installation)
• Do not use the HRV unit or an air suction/discharge grille in the following places.
a. Place subjected to high temperature or direct flame.
Avoid a place where the temperature near the HRV unit and the air suction/discharge air grille
exceeds 40°C. If the unit is used at high temperature, deformed air filter and heat exchange element
or burned motor result.
b. Place such as kitchens or other places where oil fumes are present.
This may cause fire.
c. Place such as machinery plant and chemical plant where gas, which contains noxius gas or
corrosive components of materials such as acid, alkali, organic solvent and paint, is
generated.
Place where combustible gas leakage is likely.
This may cause gas poisoning or fires.
d. Place such as bathroom subjected to moisture.
Electric leak or electric shock and other failure can be caused.
e. Locations below freezing point.
f. Near machinery emitting electromagnetic waves.
Electromagnetic waves may disturb the operation of the control system and result in a malfunction of
the equipment.
g. Place subjected to much carbon black.
Carbon black attaches to air filter and heat exchange element, marking them unable to use.
• Is a snow protection measure taken?
For detail, consult your dealer.
Summary of Contents for VAM 350GJVE
