Si71-502
Operation
Operation
11
1.2
Operation HRV Units with the Remote Control exclusively for Air Conditioning
Operation. (BRC301B61)
For non-independent systems, starting/stopping operation and timer operation may not be possible.
Use the air conditioner remote control or the Centralized controller in such cases.
Remote Controller
for HRV
BRC301B61
Operation for
INDIVIDUAL
SYSTEM
1. Operation lamp
This pilot lamp (red) light up while the unit is in Operation.
2. Operation/Stop button
When pushed once, the unit starts operating.
When pushed twice, the unit stops.
3. Air flow rate changeover button
Air flow rate can be changed over to
“
”
[Low] mode or
“
”
[High] mode,
“
FRESH UP
”
[Low FRESH UP] mode,
“
FRESH UP
”
[High FRESH UP] mode.
For
“
FRESH UP
”
operation
When this indication does not show: The volume of outdoor air supplied into the room and that of the room
air exhausted outdoors is equivalent.
For
“
FRESH UP
”
operation,
If it is set to
“
Fresh up air supply
”
: The volume of outdoor air supplied into the room is larger than that of
room air exhausted outdoors.
(This operation prevents the odor and moisture from kitchens and toilets from flowing into the rooms.
If it is set to
“
Fresh up air exhaust
”
: The volume of room air exhausted outdoors is larger than that of
outdoor air supplied into the room.
(This operation prevents the hospital odor and floating bacteria from flowing out to the corridors.)
1
2
7
5
6
11
12
13
10
8
4
3
9
(HL006)
Summary of Contents for VAM 350GJVE
