Address Setting for Wireless Remote Controller
SiME341909EA
44
Part 3 Remote Controller
4. Address Setting for Wireless Remote Controller
If setting multiple wireless remote controllers to operate in one room, perform address setting
for the receiver and the wireless remote controller.
(This includes an individual remote controller control using the group operation.)
(For the wiring for the group operation, please refer to the installation manual attached to the
indoor unit and technical guide.)
4.1 Setting for Signal Receiver PCB
The address for the receiver is set to 1 at the factory. To change the setting, set the wireless
address switch (SS2) on the signal receiver PCB according to the table below.
Unit No.
No. 1
No. 2
No. 3
Wireless address
switch (SS2)
1 2 3
1 2 3
1 2 3
Transmitter assembly
1
2 3
M
S
SS2
SS1
The side painted black indicates
the switch knob position.
Summary of Contents for VRV X RXQ10ARYFK
Page 1: ...Service Manual Cooling Only 50 60 Hz RXQ6 48A N R Series SiME341909EA...
Page 289: ...SiME341909EA Wiring Diagrams Part 7 Appendix 283 RXQ10 12ARYFK 2D124184...
Page 290: ...Wiring Diagrams SiME341909EA 284 Part 7 Appendix RXQ14 16ARYFK 2D124183...
Page 295: ...SiME341909EA Wiring Diagrams Part 7 Appendix 289 FXMQ40 50 63 80 100ARV1 3D127112 04 59...
