1.
Remove the tapping screws that attach the lamp
assembly and trimplate to the overhead console.
2.
Separate the lamp assembly from the trimplate
and disconnect the wiring harness.
3.
Replace the lamp assembly.
4.
Snap the lamp assembly and trimplate together.
5.
Connect the lamp assembly to the wiring har-
ness.
6.
Insert the tabs on the trimplate into the slots on
the overhead console attachment plate.
7.
Center the lamp assembly in the headliner cutout
and install the center tapping screw.
8.
Install the remaining tapping screws.
Dome Light Switches
In the standard cab, there is one dome light switch in
the driver’s door that turns on the diffuse dome light
when the driver’s door is opened. In one option, two
switches are installed, so that the diffuse dome light
turns on when either the driver’s or passenger’s door
is opened.
Clear Reading Lights, Optional
Clear reading lights are available as a option. They
are included only in the light assembly installed in
the overhead console, located next to the diffuse
dome light in the same fixture (
Fig. 4.9
). Like the
dome lights, the reading lights are door-activated.
Multifunction Turn Signal
Switch
The multifunction turn signal switch is attached to the
steering column, just below the steering wheel, on
the left-hand side. This switch has the following
functions:
•
The turn signals
•
The windshield wipers and washers
•
The headlight high beams
•
The hazard warning flasher
See
Fig. 4.10
for the multifunction switch and its
component parts.
Turn-Signal Controls
The turn signal lever (
Fig. 4.11
) is mounted on the
steering column. Moving the lever down turns on the
left turn signal lights; moving it up turns on the right
turn signal lights.
When one of the turn-signal lights is on, a green indi-
cator arrow flashes at the far left or far right of the
warning and indicator light panel.
f820386
1
2
3
4
5
11/16/2001
Press down on the upper part of the rocker to activate
the hazard warning flashers.
1.
Washer Button
2.
Wiper Control Dial
3.
Turn Signal Lever
4.
Hazard Flasher (red rocker switch)
5.
Multifunction Switch Module
Fig. 4.10, Multifunction Turn Signal Switch
10/17/2001
f820384
Move the lever down to turn on the left turn signals.
Move the lever up to turn on the right turn signals.
Fig. 4.11, Turn Signal Controls
Controls
4.5
