AR33.15-P-0160-02T
Press torque strut rubber bushing in/out
220 589 06 43 00
Press out/in tool
Variants of rubber mounts
A
Conventional rubber mount
a = 45 mm
B
Hydro-mount
b = 60 mm
P33.15-2095-10
Press out
1
Apply extraction tool to the unchamfered side of the torque strut and press out the
rubber mount (1).
With variant A 220 589 06 43 06 (6) and 220 589 06 43 04 (4) from
use press
out/in tool.
With variant B 220 589 06 43 06 (6) and 220 589 06 43 05 (4) from
use press out/
in tool.
2
Check bearing seat in torque strut (2).
Should the bearing seat have clearly noticeable scores, the torque strut (2) should
be replaced
P33.15-2058-02
Pressing in
During alignment pay attention to the installation position of the
rubber mount (1). The elongated hole (3) must point to the center
3
Turn over the torque strut (2) and align the rubber mount (1)
of the ball head (4).
at the chamfered side (chamfer 2 mm x 45°).
P33.15-2055-07
Variant A
The raised bead (5) can point upwards or downwards.
Page 1 of 2
© Daimler AG, 1/31/16, G/10/15, ar33.15-p-0160-02t, Press torque strut rubber bushing in/out
MODEL 211 MODEL 219 MODEL 230 except CODE (P99) Special model "AMG Black Series" MODEL 231
