Installation Guide
Daintree
®
Networked Wireless Fixture Adapter (WFA100-SN)
5
Figure 8: Dimming Ballast(s), Photosensor configuration
Figure 9: Dimming Ballast(s), Photosensor, Occupancy
Sensor configuration
Figure 5: On/Off (non-dimming) Ballasts
Perform Installation Test Suite 3
3
Wiring Continued
This configuration allows the WFA100-SN to provide automatic
0-10V dimming control and to switch ballasts On/Off. It also
provides an analog photosensor input (0-10V).
Remove the
jumper from the violet and gray terminals before connecting
the 0-10V dimming control wires.
This configuration allows the WFA100-SN to provide automatic 0-10V
dimming control and to switch ballasts On/Off. It also provides an
occupancy sensor input. Set occupancy sensor for minimum time
delay.
Remove the jumper from the violet and gray terminals before
connecting the 0-10V dimming control wires. Remove the jumper
from the blue and gray terminals before connecting the occupancy
sensor wires.
Perform Installation Test Suite 4
