Installation Guide
Daintree
®
Networked Sensor Adapter (WSA10)
6
6
Operation with ControlScope Manager
Once joined to the ZigBee network, the WSA10 and its
connected devices are assigned to zones using the Zone and
Device Configuration page. Notice that each connected input
is listed as a separate device. The Device ID and Model columns
include terminal identifiers for each connected device. These
identifiers are automatic and carry over to both the Devices
page and Zone Temperature Logging reports.
Each connected input is also assigned a Device Profile, which
determines if an alarm is generated when the sensor reports
a reading outside of the designated range.
7
Reports
The Zone Temperature Analysis report displays temperature
and time as reported by a temperature sensor or thermostat.
It also displays a histogram representing the time spent at
various temperatures over the report time period.
When a time is selected on the histogram, the number of hours
spent above or below the selected temperature also displays.
An input’s Device Profile can be configured to generate a
threshold alarm when a temperature is outside of designated
limits, as shown below. When an input is shorted or open, a
failure alarm is raised against the device, as shown below.
Alert Emails
An Email Rule can be set up to automatically send an email
when a temperature alarm is generated, or when other alerts
occur. See Email Alert Rules in the CSM online help for more
information.
8
Alarms
