Installation Guide
Daintree
®
Networked Wireless Thermostat (WTS10)
2
1
Installation Process Continued
2
Wiring: Thermostat Terminals
3
Testing
7.
On the thermostat body, locate switch SW1 on the circuit
board as shown below. This is used to set the thermostat for
operation with the HVAC system.
To prevent electrical shorts and potential damage to the
thermostat, ensure all of the base wire connections are secure
and are not touching any other terminal. Push any excess wire
back into the wall cavity and insulate the wire opening with
suitable material.
8.
Set switches as appropriate for your system:
9
. Attach the thermostat front body to the base, being
careful to align the terminal pins on the front body with
the terminal block on the base.
10
. Restore system power.
11
. Test the thermostat according to the procedure in the
Test
section for the connected HVAC system.
12
. Set the time and date on the thermostat. See the
“Keypad Operation Guide.”
13
. Review the default program schedules in the
“Keypad
Operation Guide”
and adjust as necessary.
14
. When you are ready to commission the wireless network,
see
Joining the ZigBee Wireless Network.
System
Type
Source
Switch #1
Switch#2
Conventional
Heat Pump
Electric
Gas
Heat
Changeover
Valve
Cool
Changeover
Valve
E/B (on, up)
G/O (off, down)
E/B (on, up)
G/O (off, down)
STD (on, up)
HP (off, down)
READ BEFORE TESTING
• Do not short across terminals on the gas valve or at the heating
or cooling system control board to test the thermostat installation.
This could damage the thermostat and void the warranty.
• Do not select COOL mode if the outside temperature is below
50° F (10° C). This could damage the controlled cooling system and
cause personal injury.
• Ensure the power supply is correct and the display is reading
current room temperature.
WARNING
