2
The command and information keypad can be used to operate an intrusion protection system from outside or inside the
home.
The keypad commands can be accessed:
• using the master code,
• using the 8 user codes.
Each command is confirmed with an audible signal and a visual signal (LED) issued by the keypad. The keypad also
indicates the system status and any faults or open doors or windows.
The keypad is protected against:
• opening,
• removal,
• attempts to discover the access code.
1. Introduction
8 command buttons
can be personalised
Two-colour LED
Buttons
for access codes
and programming
Arm
If the level of lighting is low or a button is pressed, the buttons and keypad are back-lit for 10 s.
The back-lighting period is repeated for 10 s when the last key is pressed.
Disarm
Partial 1
Partial 2
Arm Presence
System status query
Not allocated
Not allocated
1.1 LED indications
LED
LED status
Meaning
Red
steady
button pressed correctly
1 flash every 5 s
keypad in test mode
2 flashes every 10 s
keypad in installation mode
3 quick flashes
handling or programming error, access code invalid
Green
steady for 2 s
correct programming
steady for 10 s
access code valid (the 10 s period is repeated after each command)
IMPORTANT
• Some functions are only available with control panel versions 2.0.0 or later (enter
on the control
panel keypad to check the version).
• Operational differences in relation to former ranges are described in the compatibility booklet available in the Daitem Installers
section at www.daitem.co.uk.
