32
CARE AND MAINTENANCE
CARE AND MAINTENANCE
IMPORTANT:
1) Be sure to unplug the unit before cleaning or
servicing.
2) Do not use gasoline, thinner or other
chemicals to clean the unit.
3) Do not wash the unit directly under a tap or
using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be
repaired by manufacture or its agency.
1. Air filter
Clean the air filter at least once every two
weeks to prevent inferior fan operation because
of dust.
- Removal This unit has two filters. Take the
upper filter out along the the arrow direction
(Fig.23),then take the filter down.
Remove the lower filter by loosening the screw,
taking out the filter as shown in Fig.23.
- Cleaning Wash the air filter by immersing it
gently in warm water (about 40ºC/104ºF) with a
neutral detergent. Rinse the filter and dry it in a
shady place.
- Mounting Install the upper air filter after
cleaning , and install the lower filter by using the
screw (see Fig.24).
2. Unit enclosure
- Use a lint-free cloth soaked with neutral
detergent to clean the unit enclosure. Finished
by a dry clean cloth.
3. Unit idle for a long time
- Remove the rubber plug at the back of the
unit and attach a hose to drain outlet. Place
the open end of the hose directly over the drain
area in your basement floor (See Fig.20 & 21).
- Remove the plug from the bottom drain outlet,
all the water in the bottom tray would drain out
(See Fig.22).
- Keep the appliance running on FAN mode for
half a day in a warm room to dry the appliance
inside and prevent mold forming.
- Stop the appliance and unplug it, wrapped
the cord and bundle it with the tape(Fig.25).
Remove the batteries from the remote
controller.
- Clean the air filter and reinstall it.
Upper filter
(take out)
Remove the
screw, then take
the lower filter
out
Upper filter
(install)
Install the lower
filter by using the
screw
Power plug
socket
Power plug
Power cord
Buckle
Fig. 24
Fig. 23
Fig. 25
