10
The main pipes in the heating system should be connected to the radiator
installation by using the connection parts as seen in the installation diagram
(records, valves, nipples).
CAUTION: Depending on the climatic conditions of the regions, certain
amounts of antifreeze must be added. Our company is not responsible for
any damages caused by not using antifreeze.
CAUTION: The plumbing pipes should not be routed as far as possible
through concrete floors and should be isolated if required. Otherwise, it
cannot get enough efficiency, heat loss may occur.
5. STOVE WORK PRINCIPLES
The stove should only be used by adults. Children should not be alone with the
stove. The stove should only be used in accordance with this manual.
5.1 SUITABLE FUEL
Stove is suitable for highly efficient fuels. Approved fuel for combustion is listed in
the attached information sheet.
CAUTION : Since wood is not a permanently combustible fuel, it is impossible
to heat overnight
CAUTION: Never use wallpaper, chipboard waste, plastic or treated wood
(paint, coating, etc.) for heating! Otherwise, the chimney and flue pipes may
be blocked.
Caution: Do not use flammable materials (thinner, paint, gasoline etc.)
5.2 FIRST USE OF STOVE
After the installation process of the product is completed, heating water
(installation water) will being added to the stove and radiators. The added water
could be observed from the water level indicator of the expansion tank. Check if
there are any leakages in the installation and radiators, in case of no leakage
connect the product plug to the electrical power.
Check the electrical power and observe the light and whether the inner shaft
rotates, by removing the yellow screw located in the middle part of the circulating
pump. If the shaft does not rotate, rotate it with the screwdriver, and put the
yellow screw in place.
