9
Line data input
(Daiwa braided line)
All you have to do is just to input line data spooling the reel with
Daiwa Braided Line
.
It is a useful method because it requires less data input.
1.
Run line through the levelwind guide and tie it onto the spool.
The levelwind threader makes this process easier. Make sure
to tie the line onto the pin found on the spool to avoid the line
slipping.
2.
Move the power lever to the OFF position.
5.
Wind the line to its end with the power lever at maximum.
-Wind line under tension (about 1 kg.).
-Drag should have enough tension to wind line without
slipping.
-Be careful not to wind the end of the line onto the reel.
3.
Connect the clip to the power source (12V DC).
4.
Attach the cord connector to the reel.
See in page 2 for the connection method.
1
Levelwind Guide
Main line
Pin
Power lever
2
6
5
Attention
Do not reel in the end of the line
6.
While “
0.0
” is shown in the display, press
INVERSE COUNTER
BUTTON
and
JIG/PICKUP
BUTTON
simultaneously and hold
for 6 seconds, until the display shows
P0
on left area of the
display.
P0 Line Input Mode
The display will change to the pickup mode 2 seconds after the
buttons are pressed, but keep pressing the buttons, and the
display will change to the line setting mode.
This will show the line setting display.
If the line is wound indoors at a low speed and with a high tension for a long period of time
(*1), the motor will be overheated, which may cause motor failure. Tilt the power lever to
the MAX position before inputting a value. This issue does not need to be considered
during fishing because the motor will be cooled by sea water.
(*1) If the line is wound continuously for 10 minutes, the motor overheat prevention
function will start to work, which will stop the motor. In this case, the display will start to
blink and any operation will become unavailable for 5 minutes. When the countdown
display on the chumming timer indicator area reaches “
” (min.), a beep will
sound and data inputting will become available again from the state immediately before
the motor stoppage.
pursuetheoutdoors.com/schematics
