36
Contact trigger load
Fig.6
1)
Disconnect the too I from the air repetitive.
2)
Remove the O-Ring from the trigger pin.
3)
Pull I the trigger out.
4)
Put the red trigger on.
5)
Push the trigger pin back, using a little hammer if necessary.
6)Put the O-Ring back to fasten the trigger pin.
7) Grip the tool firmly to maintain control. Position the nose Of the tool onto the work surface.
8) Squeez and hold the trigger, push the tool against the work surface to depress the workpiece contact and
drive a nail.
1)
Pu11 the trigger with the too I off the work piece.
2)
. Depress the safety against the workpiece to drive a nail.
3)
Move the tool along the workpiece with a bouncing motion. Each depression of the safety will
drive a nail.
As soon as the desired number of nails have been driven, remove finger from the trigger.
NOTE:
Always handle nails and package carefully. If nails are dropped, collating bent may be broken, which will
cause mis-feeding and jamming.
After nailing:
1
）
Disconnect
air hose from the tool.
2
）
Remove all nails from the tool.
3
）
Supply
5-10 drops of pneumatic tool lubricant into the air plug on the tool.
4
）
Open tie petcock on the air compressor tank to drain any moisture.
Cold weather operation
Warning
Do not use a frozen tool. Allow tool to thaw before using. Moisture frozen in the tool may impede internal
components resulting in the risk of injury and/or tool damage.
When using the tool in cold conditions the tool will cycle slower than usual while driving the first nails. The
cycle rate will increase as the tool warms up. Keep tool warm to avoid reduced cycle rate.
Adjusting the nailing depth
Warning
Disconnect the tool from the air source before making adjustments. Such precautionary safety measures
reduce the risk or unintentional tool operation.
1. Disconnect tool from air supply.
2. Remove nails from the tool.
3. Adjust tool driving depth:
•To reduce the nail depth, turn the adjustment knob counter clockwise (FIG 7).
•To drive the rail deeper, turn the adjustment knob clockwise (FIG 8).
4. Reload nails as described in the "Loading Nails" section of this manual.
5.Reconnect air supply.
Summary of Contents for XI3490
