Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
18
REV122021
977701V
TROUBLESHOOTING
SYMPTOM
CAUSE
SOLUTION
Machine does not turn on
Machine not plugged in
Plug in to proper receptacle
Frequency drive has an error Clear error by turning drill off
and back on
Too long or not correct
extension cord
Remove extension cord and
plug directly in to receptacle
Emergency stop button is
activated
Deactivate emergency button
Belt cover is open
Close belt cover
Noisy Operation
Incorrect belt tension
Adjust tension, see “Speed
Adjustment” section of this
manual
Loose spindle or motor pulley Check for wear or if pulley
can be tightened
Spindle bearing worn
Replace bearing
Chuck or quills fall out
Rust inhibitor, dirt, debris in
or on quill or spindle taper
Clean chuck and quill
Spindle does not move up or
down
Belt is broken or slipping
Check belt for damage and
replace if needed. Check for
proper belt tension, see
“Speed Adjustment” section
of this manual
Debris in quill
Clean quill and teeth
Feed depth adjustment is set See “Feed Depth Adjustment”
in this manual
Spindle does not rotate
Belt tension is too loose
Tighten belt tension, see
“Speed Adjustment” section
of this manual
Belt is broken or worn
Replace belt
Taper is slipping in spindle
Clean chuck and quill
Motor is not rotating
Troubleshoot motor or
contact DAKE
