Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
8
REV122021
977701V
•
Use recommended accessories. The use of improper accessories may cause risk of
injury.
•
Adjust the table or depth stop to avoiding drilling into the table, shut off the power.
Remove the drill bit or cutting tool, and clean the table before leaving the machine.
•
Do not operate until completely assembled and installed according to the instructions.
•
If any part of your drill press is malfunctioning, has been damaged, or broken do not
operate until the part is properly repaired or replaced.
•
Lockout the motor switch when leaving the drill press. Don’t perform layout, assembly, or
setup work on the table while the cutting tools rotating.
Voltage Warning:
•
Before connecting the machine to a power source know your incoming voltage.
•
At power source with voltage greater than that specified for the machine can result in
serious injury to the user and can damage the machine.
•
Using a power source with voltage less than that of the machines rating can damage the
motor and other components.
•
If you are unsure of the voltage rating do not use the machine.
•
Extension cords and surge protectors are not recommended for this product.
•
Ground fault circuit interrupters (GFCI) should not be used.
•
No not tamped with the wiring or settings inside the frequency drive.
