- 16 -
QUICK VISE ADJUSTMENT FOR ANGLE CUT (912DR.912GDR)
(1). Pull out plastic knob (A).turn and lock the plastic knob.
(2). Loosen grip (B).Then rotates the Body Frame for the desired angle. Be aware the blade
Position is higher than the Vise Table by pulling up the Body Frame when
counter-clockwise
Rotation for miter cutting. And for clockwise rotation for angle cutting higher the Body
Frame and keep the blade position higher than the vise. Then pull forward the vise Jaw
Bracket (Front) to a proper location.
(4). Fasten the grip (B) when the cutting angle is reached.
(5). There is angle set-screw for
45
rotation
8. BLADE GUIDE BEARING ADJUSTMENT
ATTENTION: This is the most important adjustment on your saw. It is impossible to get
satisfactory work from your saw if the blade guides are not properly adjusted. The blade guide
bearings on your metal. Cutting Band Saw are adjusted and power tested with several test cuts
before leaving the factory to insure proper setting The need for adjustment should rarely occur
when the saw is used properly. If the guides do get out of adjustment though, it is extremely
important to readjust immediately. If improper adjustment in maintained, the blade will not cut
straight, and if the situation is not corrected it will cause serious blade damage. Because guide
adjustment is a critical factor in the performance of your saw, it is always best to try a new blade to
see if this will correct poor cutting before beginning to adjust. If a blade becomes dull on one side
sooner than the other, for example, it will begin cutting crooked. A blade change will correct this
problem the guide adjustment will not. If a new blade does not correct the problem, check the blade
A
B
Summary of Contents for SE-912
Page 23: ... 23 ELECTRICAL SPECIFICATION ...
Page 24: ... 24 ...
Page 25: ... 25 ...
Page 26: ... 26 ...
