4. After you choose a tune, activate the wireless probe transmitter by pressing the “A”
button on the transmitter board (SEE DIAGRAM NEXT PAGE).
5. If you are programming more than one transmitter, repeat steps 3 & 4.
6. After your transmitter(s) are coded, press and hold the
MODE
button until the LEDs stop
flashing (about three seconds).
7. To test the tune, activate the wireless probe transmitter by pressing the “A” button again.
You should hear the selected tune and see the lights flash on your receiver.
Note:
You can connect up to 16 transmitters with your receiver
1. Place your receiver and wireless probe transmitter near each other.
Note:
Do not move or place metal near the probe until you select the tune you want.
2. Press and hold the
MODE
button for three seconds. When all four lights flash, release
the button.
3. Press the (volume) repeatedly until you find the tune you want to use.
CODING YOUR RECEIVER
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Ding Dong (high)
Ding Dong (low)
Westminster
Fur Elise
Alarm/Siren
Coo Coo Clock
Bird Chirping
Twinkle Twinkle
William Tell
Cannon in D
Morning
Toreador March
Beep (high)
Beep (low)
Beep, Beep
Beep, Beep,
Beep Beep
DCR-4000 & RE-4k Plus
RE-4k Plus
