[10]
MAN #650819A
Troubleshooting guide:
Problem
Possible cause
Solution
No BIM data on instrument readout;
BIM does not light up.
PWR wire does not have power.
GND wire is not properly grounded.
Power/data harness is damaged.
Module is damaged.
Connect to a location that has +12V key-on power.
Connect to a different ground location.
Inspect harness. Repair or replace any damaged
areas.
Return for service. (see instructions)
No BIM data on instrument readout;
BIM display is sca
nning “BUS”
CAN Interface cable is not connected
FiTech CAN outputs are not enabled
Connect the supplied CAN interface cable between
the BIM unit and the ECU
’s CAN output.
Enable CAN outputs using the FiTech handheld
(see pg. 7)
No BIM data on instrument readout;
BIM has a steady dot lit.
Interface cable is not connected.
Interface cable is loose.
On VHX systems, the BIM display for
this channel is disabled.
Connect the supplied harness between the BIM
unit and the instrument system control box.
Ensure both ends of the cable are seated securely.
Follow instructions in VHX manual to enable the
BIM display screen.
BIM d
isplay shows “
:
”
Data cable is damaged or connected
improperly.
Another module on the bus is damaged.
Inspect and replace harness or power/data
harness.
Inspect other modules on the data bus.
Summary of Contents for BIM-01-2-FTCH
Page 11: ...11 MAN 650819A Notes...
