MAN# 650199
Setting the warning limits, gauge setup, and update speed:
The SND terminal is used to enter and change the warning settings. You will need a wire connected to the
SND terminal that can be momentarily powered while you watch the gauge. The headlights should be off or the DIM
terminal unhooked so that it does not interfere with the setup.
Make sure that the sender is not connected while this is done.
1. To enter the set mode, turn the key on with the SND wire not touching anything. The gauge will display
“SEt”.
2. Power the SND wire. The gauge will display “ HI”.
3. Release the SND wire. The gauge will display the current high warning pressure.
4. Each time you momentarily power the SND wire the number will change.
5. When the desired high warning value is displayed, keep the SND wire powered for about 2 seconds. The
gauge will display “LO”.
6. Release the SND wire. The gauge will display the current low warning pressure.
7. Each time you momentarily power the SND wire the number will change.
8. When the desired high warning value is displayed, keep the SND wire powered for about 2 seconds. The
gauge will display “SPd”.
9. Release the SND wire. The gauge will display the current update speed. (“SLO” for slow, “FSt” for fast, and
“HLd” for peak hold)
10. Each time you momentarily power the SND wire the setting will change.
11. When the desired update speed is displayed, keep the SND wire powered for about 2 seconds. The gauge
will display “--”.
12. Turn the key off.
Troubleshooting guide.
Problem
Possible cause
Solution
Gauge will not light up
PWR terminal does not have power.
Connect to a location that has power.
GND terminal does not have a good
Connect to a different ground location.
ground.
Gauge is damaged.
Return gauge for service. (see instructions)
Gauge lights up, but does
Loose connection on SND terminal.
Reconnect wire.
not read correctly.
Poor ground connection.
Move ground to different location
Gauge is sender setup is incorrect.
See “Setting sender setup” in the manual.
Voltage or wiring problem in the
Check wiring harness for loose or damaged wires.
vehicle wiring harness.
Gauge lights up, but displays Gauge is damaged.
Gauge must be returned for service. (see instructions)
“Er0”.
Gauge lights up, but displays SND terminal is shorted to ground.
Check wire for damaged insulation. Replace if necessary.
“---”.
Sender is damaged.
Replace sender.
Sender is not connected to gauge.
Connect SND terminal on gauge to sender terminal.
Wire between gauge and sender is
Test and replace wire.
broken.
Sender is damaged.
Replace sender.
Gauge is damaged.
Return gauge for service. (see instructions)
Gauge lights up, but displays Gauge is sender setup needs to be
See “Setting sender setup” in the manual.
“Er4”.
reset.
Gauge lights up, but displays Gauge warning points need to be
See “Setting the warning limits” in the manual.
“Er5”.
reset.
Gauge flashes constantly.
Warning limits are not set properly.
Reset warning limits.
Pressure is too low or too high.
Check engine.
Gauge will not dim.
DIM terminal is not connected correctly. Check wiring connections.
Gauge remains dim at all
DIM terminal is getting power all
Connect DIM wire to location that only has power when the headlights
times.
of the time.
are on.
Battery is very low.
Recharge or replace vehicle battery.
Gauge is damaged.
Return gauge for service. (see instructions)
