18
Safety
Anchorages must be able to support 5,000 pounds per attached employee and must be free
from anchorages supporting the platforms. Anchorages must be at, or above, D-ring height.
Daktronics requires 100 percent tie-off when PFAS is required. One-hundred percent tie-off
means that the lanyard is always attached to an anchorage point. A double-leg lanyard is
required so personnel can attach the second leg to an anchorage before disconnecting
the first.
Inspect PFAS for damage and deterioration before each use. Damage may occur from cuts,
acids, tears, D-ring distortion, and frayed edges. Remove defective components from service.
8.3 Lift Equipment and Aerial Lifts
General Requirements
Aerial lifts include the following types of vehicle-mounted aerial devices used to elevate
personnel to job-sites above ground:
•
Extendable boom platforms
•
Aerial ladders
•
Articulating boom platforms
•
Vertical towers
•
Any combination of such devices
Specific Requirements
•
Test lift controls prior to use each day to verify they are in safe working order.
•
Only authorized persons shall operate aerial lifts.
•
Always stand firmly on the basket floor. Do not sit, climb, or stand on the edge of
the basket.
•
Do not exceed manufacturer’s boom and basket weight requirements.
8.4 Employee Training Requirements
The following is a list of Daktronics required or recommended classes for employees. ASCs
should have all relevant training required by their company.
Advanced Fall Protection
Advanced fall protection is provided at Daktronics, and is mandatory for all employees who
might be exposed to fall hazards, particularly those who will wear a PFAS.
