4
Display Installation
•
Webcam
•
Photo sensor
•
Top and bottom borders
•
Spare parts box
•
Hardware for section splice (if applicable)
•
Hardware for attaching the display to the structure.
3.
Remove bracing between display sections.
2.4 Display Installation
1.
Remove the top bracing between the sections.
2.
Locate and open the crates with the borders inside.
3.
The top borders have large holes on the top and drip
lips along both sides. Lay the borders on the ground
in order from left to right. For additional
information on borders refer to
Drawing B-265098
in
Appendix A.
Note:
Top borders are labeled. Labels end with an
“A” and indicate order from left to right when
facing the front of the display. Refer to
4.
Locate the end caps. Apply a bead of silicone along the lip with the bolt holes on the end
cap. Fasten one end cap to each piece.
5.
Attach a splice plate on one end of each border piece.
Note:
To protect against water, apply silicone to
the top of the splice plates along the bolt holes
on each side before fastening to the top border.
6.
After removing the shipping braces, lay the top
border on the top section and fasten the border
Note:
Fasten the border starting on the side of
the display closest to traffic.
7.
Apply silicone and screw all border
pieces together.
8.
Hook the spreader beam into the eyebolts on top of the display. Refer to
ED-16454
in
Appendix B
for spreader beam specifications.
9.
Lift the display enough to apply tension on the top section.
Figure 2: Top and Bottom Borders
Figure 3: Fastening Top Border
