Mechanical Installation
7
2.3 Ad Panel Mounting
Unistrut Attachment
1.
Using the backup channel as a
template, drill four
7
/
16
" holes in
the upper and lower rear flanges
of the ad panel where the beams
will be located.
Note:
Try to ensure that the two
center holes will be within the
width of the beam.
2.
If the ad panel has backsheets,
remove them as needed to
access the ad panel interior.
3.
Attach the piece of unistrut to
the ad panel with the included
hardware, as shown in
4.
If any backsheets were removed,
put them back on at this time.
5.
Place spring nuts into the unistrut. Twist the spring nuts until they are perpendicular
to the unistrut channel (refer to
from
Section 2.2
Once the unistrut is attached and the spring nuts are in place, refer to the appropriate section
below for the type of mounting hardware provided with the ad panel.
Figure 8:
Mounting Tube Attachment, Side View
Figure 9:
Unistrut Attachment, Side View
