Signal Cable Installation
8
5 Signal Cable Installation
Primary/Mirror Display Interconnections
For data to get from the Primary display to the Mirror
display, the interconnect cable must be connected. This
cable typically comes attached to the rear of the display.
1�
Locate the cable, unpackage it, and remove
protective caps from cables.
2�
If this display is a two-sided primary/mirror display,
quick-connect cables are provided to connect the
signal between the two faces. Refer to options 1 and
2 below for your specific application.
Option 1:
Connect a cable from the Signal Out jack
on primary face to Signal In jack on mirror face.
Connect a second cable from the Signal Out jack
on the mirror face to the Signal In jack on the primary
face.
Option 2:
Install the fiber quick-connect cable
between Primary and Mirror display faces when
applicable.
3�
Coil up any excess cable and secure it to prevent
vandalism and weather-related damage.
Note:
Anchor points are found on each fan hood to
secure excess cable.
Figure 7:
Signal Out Jack
Figure 8:
Signal In and Out Jacks