Setup
4
Video Camera Connection
The connection between the camera or video source and the All Sport CG is always via
wire. The video signal is carried via HDMI cable from the
VIDEO OUT
jack on the video
camera to the
VIDEO IN
jack on the bottom of the All Sport CG.
Note:
If the video camera only outputs an SDI signal, an SDI-to-HDMI converter
is required between the video camera and the All Sport CG HDMI input
(Daktronics part # A-3018).
Recording Device Connection
The connection between the recording device and All Sport CG is always via wire. An
HDMI cable sends the combined data via a connection from the
VIDEO OUT
jack on the
bottom of the All Sport CG to the
VIDEO IN
jack on the recording device.
Note:
If the recording device only has an SDI signal input, an HDMI-to-SDI converter
is required between the recording device and the All Sport CG HDMI output
(Daktronics part # A-3313901).
All Sport Controller Connection
There are three ways to get scoring information into the All Sport CG (each method is
also detailed in
DWG-3192029
located in
Appendix A
):
• Wire connection between the All Sport CG and the All Sport controller
• Wireless radio signal between the All Sport CG and the All Sport controller
• All Sport CG used manually (no All Sport controller required)
Wire Connection
For a wire connection, game-in-progress data is sent through a cable from the 1/4"
phone jack (
J1
,
J2
, or
J3
) on the back of the All Sport 5000 or 5500 controller to the 9-pin
DATA
port on top of the All Sport CG.
Wireless Radio Connection
When the wireless radio option is used, game-in-progress data is sent via radio signal from
the All Sport 5000 or 5500 controller equipped with a radio transmitter to the All Sport CG
with a radio receiver. The radio signal has a communication distance of up to 500' (152
m) indoor or 1500' (457 m) outdoor with a clear line of sight.
If an internal radio is detected when the All Sport CG is
turned on, the operator will be prompted for a Broadcast
Group. Enter the corresponding Broadcast Group setting
from the All Sport controller, and then press
<ENTER */EDIT>
.
Next, a prompt will appear to enter the Channel Number.
Enter the corresponding Channel Number setting from the
All Sport controller, and then press
<ENTER */EDIT>
.
Refer to the appropriate All Sport controller operation manual listed in
for detailed instructions on selecting the proper Broadcast Group and Channel
Number being used to control the scoreboard.
BROADCAST GROUP
FOR RADIO 0*
CHANNEL NUMBER
FOR RADIO 0*
