Mechanical Installation
4
3
Mechanical Installation
The display itself may feature a carrying
handle and may not require assembly or
permanent installation. Some assembly may
be required, however, for attachment of a
wheeled cart.
Cart Assembly
) comes standard
with four wheels. Included in the cart kit is an
installation quick guide (
DD3695776
). Refer
to this guide when attaching the cart to the
display.
Note:
In order to install the cart, the
triangular stands on the sides of the
display must first be removed using
a Philips screwdriver. For the TI-2203,
the carrying handles must also be
removed.
Adjusting the Cart
Reference Drawing:
Assy; Small Display w/ Stands ..........................................................................
DWG-3220250
Caution!
Do not raise the display in high winds or transport the display in the raised
position. These actions increase the likelihood of tipping over and causing injury or
damage to the display.
DWG-3220250
in
Appendix A
shows the two axle positions that may be used with
the cart. The extended axle position provides maximum stability and should be used
whenever the display is raised. Use the narrow axle position (and lowest height) to move
the display through doorways and for storage. The drawing also illustrates front profiles of
the display in transport position and at maximum viewing height.
There are three height-adjustment holes in the mounting tubes on the sides of the display.
Raise the display for viewing by removing the pins and retaining clips, sliding the display
upward on the T-stands and reinserting the pins in the appropriate holes. Lower the
display for storage or transportation. It may be helpful to have one person lift the display
while another person adjusts the locking pins.
T-Stand
Locking Pin
Wheel w/ Bolt
Axle Tube
Mounting Tube
T-Stand
Locking Pin
Wheel w/ Bolt
Axle Tube
Mounting Tube
Figure 4:
Cart Assembly
Summary of Contents for P1753
Page 4: ...This page intentionally left blank...
Page 26: ...This page intentionally left blank...
Page 28: ......
Page 38: ...This page intentionally left blank...
