Small Matrix Galaxy
®
GS6 Series
Installation Quick Guide
Page 1 of 2
DD3125374 Rev 02
08 July 2016
PO Box 5128 201 Daktronics Drive, Brookings, SD 57006-5128
tel: 800-325-8766 fax: 605-697-4700
www.daktronics.com
Step 1: Display Mounting
1.
Lift the display into position on the support structure.
2.
Weld or use
1
/
2
” hardened bolts to secure all clip
angles to support
structure
3.
Remove crane support
from the display.
4.
Remove all eyebolts if
desired. Seal all of the
remaining holes with
silicone approved for use
on aluminum.
5.
Make sure display
structure or
shrouding does
not block display
ventilation.
Step 2: Connecting Power
1.
Refer to the label on back of the display or to the
display riser drawing for power requirements.
Displays require either 120 VAC (2 wire + ground) or
120/240 (3 wire + ground).
2.
Wire Line 1, Line 2, neutral, and ground wires
according the shop drawing.
3.
Connect grounding electrode to
ground lug on each display face.
4.
Test the display ground to
ensure it has a resistance-to-
ground of 10 ohms or less.
120/240 VAC Termination
(Box with Cover Removed)
Wiring from power termination
panel inside display
Line 1 – Black
Line 2 – Red
Neutral – White
Ground –
Green/Yellow
