12
Maintenance & Troubleshooting
3.
Attaching New Speaker Mesh
When ordered through Daktronics, the mesh has a line with a series of tick marks
printed on the front (
). These tick marks are used to indicate the location of
the tension clips and mandrels.
a.
Place a mandrel, smooth side up, centered on the tick mark.
b.
Fold the mesh around the mandrel. Ensure the groove in the mandrel is
towards the inside of the mesh (
c.
Snap a tension clip over the mandrel and mesh (
). Do not try to
drive both ends of the clip down onto the mandrel and fabric at the same
time; snap one end down and then the other.
d.
Continue to place a mandrel and tension clip on every tick mark.
Figure 16:
Tick Marks on Mesh
Figure 17:
Folding Mesh
Figure 18:
Attach Tension Clip
