Maintenance
13
a�
Place a mandrel, smooth side up, centered on
the tick mark.
b�
Fold the mesh around the mandrel. Ensure the
groove in the mandrel is towards the inside of
the mesh (
c�
Snap a tension clip over the mandrel and
). Do not try to drive both ends
of the clip down onto the mandrel and fabric
at the same time; snap one end down and
then the other.
d�
Continue to place a mandrel and tension clip
on every tick mark.
e�
Lay the mesh across the frame and snap each
clip into the tension channels (
).
f�
Pull on the corners of the mesh to remove any
wrinkles. When pulling on the fabric, do not pull
directly on the fabric flap or tension clip, or the
clip may pop off. When pulling on the face,
grasp the fold and pull the face into place.
g�
Use the tensioning tool provided with the mesh
replacement kit (part # 0A-1561-0028) to drive
the tension clips into the tension channels
(
). Start with one or two clicks.
h�
Work around the frame, tightening down
all the tension clips until all the wrinkles are
removed and the mesh is properly taut.
Do not
over-tension!
This may cause damage to mesh
graphics. Apply just enough tension to achieve
a smooth, flat surface.
i�
Place the radius covers
on the end of the mesh
frame and tighten the
set screws on the radius
cover.
4�
Reattach Mesh Frame
Safely lift mesh frame back
in place on the front of the
sound cabinet and attach
with the eight (8) 3/8"
hardware sets. Ensure the
frame is snug tight against
the cabinet.
Figure 18:
Folding Mesh
Figure 19:
Attach Tension Clip
Figure 20:
Clips in Channels
Tensioning Tool
1.
Hook tip under
outside frame rail.
2.
Use handle to apply
downward force on clip.
Mesh
Mesh Frame
Figure 21:
How to Use Tensioning Tool
Summary of Contents for SPORTSOUND 500HD
