Setup & Operation 9
3.2 Mixer Operation
Basic instructions are described below. For more information about mixer
operation, refer to the
Rane MLM82S Operators Manual
.
• Ensure all source equipment is turned on and operational (refer to
appropriate pages).
•
For each input channel (source) in use, verify the following settings
as shown in
–
SIG/OL
light is green; if this light is red, decrease the level
–
ASSIGN
is set to “A+B” or “B”
Note:
Inputs set to “A” will only be heard through the announcer’s
console headphones. This may be used to listen to each input without
interrupting the main mix.
• When the input is in MONO mode, the signal goes to both “A” and “B”
outputs. The amber LED illuminates when in MONO mode (
When not in MONO mode, the input signal goes to the “B” output (as
set in the factory).
• Adjust MASTER VOLUME “B” level (
output. If the OL light is red, decrease the level.
Remember:
Bad input = bad output. No adjustment on the mixer can make a
poor source sound better. For best results, be sure to use high-quality audio files
from your MP3 player or laptop, and set the device to near full volume.
Figure 13:
Input Level Adjustment
Figure 14:
MONO Input
Figure 15:
MASTER Output
